Buy Low Price From Here Now
Powerful 13 Amp Milwaukee built motor. Perfect for drilling holes of all sizes in wood frame construction. Low speed clutch. Fast drilling with 1750 RPM high; 450 RPM low. 3-position Roto-Lok rear handle with 90deg left-right rotation. Includes side handle, 8ft. 3-wire fixed rubber cord, and impact-resistant carrying case. U.S.A. Amps: 13, Chuck Size (in.): 1/2, Speed (RPM): 450 and 1750, Cord Length (ft.): 8, Side Handle: Yes, Keyless Chuck: No, Variable Speed: Yes, Case Included: Yes
Readmore
Technical Details
- 13 amp motor delivers power for drilling holes of all sizes- Two operating speeds: max 1750 rpm-inch high, clutch-inch low gear range
- 90-degree left to right Roto-Lok handle offers maximum operating comfort
- Removable side handle offers added control
- Impact resistant carrying case-included
See more technical details
By Michaels Plumbing Inc. (edisto island, sc)
This drill is fantastic in all aspects. It handles real good and perfect for drilling big holes.
By Jamisen L. Fox (California)
Stop, don't buy this if you expect the typical quality from Milwaukee. These are now made in China. Mine broke the handle off due to a faulty trigger switch. With the switch fully depressed the drill would start and stop on its own. It almost broke my wrist. Buyer beware...china....really?
By L. Burnette
This is a very powerful drill and I have no doubt that it will drill most any size hole that you have a bit for but I think that Milwaukee should have a little better quality control.
The reason I say this is that while drilling the third 3/4" I reversed the drill to clean the bit, the chuck wound off the shaft and there between the joist was a bit half way through with the chuck attached. The only to remove them was to back them out useing a pipe wrench. Upon examination I found that the left hand threaded screw that locks the chuck on the shaft was broken allowing the chuck to unwind off the shaft when the drill was reversed. For this to happen, the screw had to be loose from the factory. A quick inspection would have prevented this and I would not have lost 2 days on a job that I needed to finish by this friday. I returned the drill for a refund and purchased the standard right angle drill instead. Needless to say I am unhappy with the delay, since I am a small contractor and should be starting another job Monday instead of having to spend another day on this one.
Amazon was very helpful in returning this item.
By Steven Charest (Auburn, ME)
I'm an electrician and I have to drill a lot of holes when roughing in a house. This drill powers through studs and floor joist like butter. I love it and would recommended it to anyone.
By Robert J. Bresnihan (STATEN ISL NY USA)
To the gentleman who reviewed the 1680-21 and gave it 4 stars for simply arriving at the house and didn't test it;"gee that makes sense" During installation of a waste line section (4") the bi-metal bit jammed on low speed. I now understand why the manual devotes significant time to being careful. Two days and some Ben-Gay does wonders.
Images Product
Buy Milwaukee 1680-21 13 amp 1/2-inch Super Hawg Joist and Stud Drill Now
0 comments:
Post a Comment